Introduction Parameter x.00
Parameter
description format
Keypad and
display
CT Modbus
RTU
User
programming
CT Soft Menu 0
Advanced parameter
descriptions
Menu 11
Commander SK Advanced User Guide 125
Issue Number: 2 www.controltechniques.com
The LED keypad can adjust this parameter even when user security is set.
When this bit is set to 1 the motor 2 parameters in menu 21 become active instead of the equivalent parameters in other menus. Changes will only be
implemented when the drive is inactive. When the motor 2 parameters are active the display will light the 2 small dashes. If motor map 1 is selected
after motor map 2 has been active the display will light 1 small dash. If this parameter is 1 when an auto-tune is carried out (Pr 5.12 = 1 or 2), the
results of the auto-tune are written to the equivalent second motor parameters instead of the normal parameters. Each time this parameter is changed
the accumulator for motor thermal protection is reset to zero.
This parameter displays the number of the last set of defaults loaded e.g. 1 Eur, 2 USA.
Value Level Access permitted
0 L1 Only the first ten parameters can be accessed.
1 L2 Parameters up to 60 can be accessed.
2 L3 Parameters up to 95 can be accessed.
3 Loc
Lock security, so that the security code must be entered before a parameter can
be edited and set security status to L1.
11.45 Select motor 2 parameters
Coding
Bit SP FI DE Txt VM DP ND RA NC NV PT US RW BU PS
111
Range 0 or 1
Default 0
Update rate Background
11.46 Defaults previously loaded
Coding
Bit SP FI DE Txt VM DP ND RA NC NV PT US RW BU PS
11111
Range 0 to 2
Default 0
Update rate Background write
To Next Page
Loading...
Need help?
General
