Introduction Parameter x.00
Parameter
description format
Keypad and
display
CT Modbus
RTU
User
programming
CT Soft Menu 0
Advanced parameter
descriptions
Menu 6
Commander SK Advanced User Guide 77
Issue Number: 2 www.controltechniques.com
LAT
XOR
+TMR
LAT
LAT
LAT
OR
AND
AND
OR
OR
LAT
Drive enable Pr
6.15
Hardware enable Pr
6.29
Not stop Pr
6.39
Run forward Pr
6.30
Run reverse Pr
6.32
Run Pr
6.34
Enable seq latching
Pr
6.40
Forward/reverse Pr
6.33
(0=fwd, 1=rev)
Jog Forward Pr
6.31
Sequencer control: normal operation
Sequencer control: keypad mode
Run key
Stop key
Drive enable Pr
6.15
Hardware enable Pr
6.29
Sequencer Run
Reverse select Pr
1.12
Jog select Pr
1.13
Sequencer run
Latch
1. If the enable input is 0 the output follows the input
2. If the enable input is 1 the output is always 0 if the reset input is active
3. If the enable input is 1 and the reset input is 0 the output latches and stays at 1 if the input is 1
Exclusive OR gate with timer
1. The output is the exclusive OR of the inputs
2. If both inputs become active the output becomes 0, but with a delay of 60ms
3. If both inputs become inactive the output becomes 0 immediately, except in modes when
Pr 0, 3 or 4 (i
6.01
.e. coast or injection stop modes) where the output becomes 0 with a delay of 60ms.
Tog gl e
1. The output changes state on each non- active to active change at the input
input
LAT
output
reset
enable
XOR
+TMR
Sequencer Enable
Jog select Pr
1.13
AND
Drive enable Pr
6.15
Hardware enable Pr
6.29
Sequencer Enable
Drive trip
Drive trip
AND
Motor stopped
OR
OR
OR
OR
Jog Reverse Pr
6.37
OR
AND
R
R
OR
R
LAT
1
OR
Not stop Pr
6.39
Defined stop condition
(see Pr )
6.12
Stop key
Enable stop
key Pr
6.12
1
OR
AND
Drive
tripped
Prevent the stop key from
causing the drive to run
TOG
AND
AND
AND
LAT
1
OR
OR
Pr = 3
6.13
LED Key status Pr
6.11
Motor stopped
AND
AND
Forward/reverse Pr
6.33
Enable seq latching Pr
6.40
TOG
OR
Reverse select Pr
1.12
To Next Page
Loading...
Need help?
General
