Conventional chassis configurations will require use of
the portable rear lifting bracket.
Attach lifting fixture, Part No. ST-125 or Part No. 3822512,
to the engine mounted lifting brackets to remove the
engine.
Cover all engine openings to prevent dirt and debris from
entering the engine.
Place the engine on suitable engine support stands.
Remove and use all remaining accessories and brackets
with the replacement engine.
Remove the service engine lifting bracket if used to re-
move the engine from the chassis. Refer to Procedure 7-
03.
Engine Removal (9-01) Section 9 - Engine Remove and Install
N14Page 9-8
To Next Page
