D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
96
all − Specifies that all ports are to be configured.
disable − Disables rate limiting.
<value 3500-1000000> The rate limit value. The value may be
between 3500 and 1000000.
Restrictions None.
Example usage:
To configure a rate limit of egress port 1:
DGS3100# config rate_limit 1:1
Success.
DGS3100#
show rate_limit
Purpose To show the rate limit of specific egress ports.
Syntax
show rate_limit [<portlist> | all]
Description The show rate_limit command displays the rate limit of an egress
port.
Parameters <portlist> − A port or range of ports whose rate limit is to be
displayed.
all − Specifies that all ports are to be displayed.
Restrictions None.
Example usage:
To show a port’s rate limit:
DGS3100# show rate_limit all
Current rate limit
Port Rate Limit
------ ---------------
1 3500
2 3500
3 3500
4 3500
5 3500
6 3500
7 3500
8 3500
9 3500
10 3500
11 3500
12 3500
13 3500
14 3500
15 3500

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C