D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
20
Description The reboot command restarts the Switch.
Parameters <box_id 1-6> − The unit’s current stack membership number.
Restrictions Only Administrator or operate-level users can issue this command.
Example usage:
To restart the Switch unit 1:
DGS3100# reboot 1
Are you sure you want to proceed with system reboot
now? (Y/N)[N] Y
This action may take a few minutes
DGS3100#
reset
Purpose To reset the Switch to the factory default settings.
Syntax
reset
Description The reset command restores the Switch’s configuration to the
default settings assigned from the factory. Execution of the reset
command through the CLI retains the unit’s current stack
membership number.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To restore all of the Switch’s parameters to their default values:
DGS3100# reset
Please be aware that all configuration will be reset to
default value.
Are you sure you want to proceed with system reset
now? (Y/N)[N] Y
Deleting auto update backup file...OK
Deleting auto update instruction file...OK
Deleting startup configuration file... Done.
Please make sure that your terminal is set to the default
baud rate - 9600 bps.
This action may take a few minutes
Success.
DGS3100#
login
Purpose To log in a user to the Switch’s console.
Syntax
login

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C