D-Link DGS-3100 SERIES - Config 802.1 X Auth_Parameter Ports

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
130
OpenCrlDir : both
Port Control : forceAuthorized
QuietPeriod : 60 sec
TxPeriod : 30 sec
SuppTimeout : 30 sec
ServerTimeout : 30 sec
MaxReq : 2 times
ReAuthPeriod : 3600 sec
ReAuthenticate : false
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
config 802.1x auth_parameter ports
Purpose
To configure the 802.1x authentication parameters on a range of
ports. The default parameter returns all ports in the specified range
to their default 802.1x settings.
Syntax config 802.1x auth_parameter ports [<portlist> | all] [default |
{ port_control [force_unauth | auto | force_auth] | quiet_period
<sec 0-65535> | tx_period <sec 1-65535> | supp_timeout <sec 1-
65535> | server_timeout <sec 1-65535> | max_req <value 1-10> |
reauth_period <sec 300-4294967295> | enable_reauth [enable |
disable]}]
Description
The config 802.1x auth_parameter ports command configures the
802.1x authentication parameters on a range of ports. The default
parameter returns all ports in the specified range to their default
802.1x settings.
Parameters
<portlist> – A port or range of ports to be configured.
all – Specifies all of the ports on the Switch.
default – Returns all of the ports in the specified range to their
802.1x default settings.
port_control – Configures the administrative control over the
authentication process for the range of ports. The options are:
• force_auth – Forces the Authenticator for the port to
become authorized. Network access is allowed.
• auto – Allows the port’s status to reflect the outcome of the
authentication process.
• force_unauth – Forces the Authenticator for the port to
become unauthorized. Network access is blocked.
quiet_period <sec 0-65535> – Configures the time interval between
authentication failure and the start of a new authentication attempt.
tx_period <sec 1-65535> - Configures the time to wait for a
response from a supplicant (user) to send EAP Request/Identity
packets.
supp_timeout <sec 1-65535> - Configures the time to wait for a
response from a supplicant (user) for all EAP packets, except for the
Request/Identity packets.
server_timeout <sec 1-65535> - Configures the length of time to wait
for a response from a RADIUS server.
max_req <value 1-10> – Configures the number of times to retry