D-Link DGS-3100 SERIES - CONFIGURING QUALITY OF SERVICE; Configuring 1 p

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
133
default – Uses the default udp port number in both the auth_port and
acct_port settings.
auth_port <udp_port_number 1-65535> – The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> – The UDP port number for
accounting requests. The default is 1813.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure the RADIUS server communication settings:
DGS3100# config radius add 10.48.74.121 key dlink default
Success.
DGS3100#
config radius delete
Purpose To delete a previously entered RADIUS server configuration.
Syntax
config radius delete <server_ip>
Description The config radius delete command deletes a previously entered
RADIUS server configuration.
Parameters <server_ip> – The IP address of the RADIUS server.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To delete previously configured RADIUS server communication settings:
DGS3100# config radius delete 10.48.74.121
Success.
DGS3100#
config radius
Purpose To configure the Switch’s RADIUS settings.
Syntax
config radius <server_ip> {| key <passwd 128> | auth_port
<udp_port_number 1-65535> | acct_port <udp_port_number 1-
65535>}
Description The config radius command configures the Switch’s RADIUS
settings.
Parameters <server_ip> – The IP address of the RADIUS server.
key – Specifies that a password and encryption key are to be used
between the Switch and the RADIUS server.
• <passwd 128> – The shared-secret key used by the
RADIUS server and the Switch. Up to 128 characters can
be used.