D-Link DGS-3100 SERIES - Show Ports

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
31
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To configure the speed of ports 1-3 to be 10 Mbps, full duplex, learning and state enabled:
DGS3100# config ports 1-3 speed 10_full learning enable state enable
Success.
DGS3100#
show ports
Purpose To display the current configuration of a range of ports.
Syntax
show ports {<portlist>}
Description The show ports command displays the current configuration of a
port or range of ports.
Parameters <portlist> − A port or range of ports whose settings are to be
displayed.
Restrictions None.
Example usage:
To display the configuration of all ports on the Switch:
DGS3100# show ports
Port Port Settings Connection Address
State Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
----- ------------ ------------------------------ ------------------------------ -----------
1:1 Enabled Auto/Disabled Link Down Enabled
1:2 Enabled Auto/Disabled Link Down Enabled
1:3 Enabled Auto/Disabled 100M/Full/Disabled Enabled
1:4 Enabled Auto/Disabled 100M/Full/Disabled Enabled
1:5 Enabled Auto/Disabled Link Down Enabled
1:6 Enabled Auto/Disabled Link Down Enabled
1:7 Enabled Auto/Disabled Link Down Enabled
1:8 Enabled Auto/Disabled Link Down Enabled
1:9 Enabled Auto/Disabled Link Down Enabled
1:10 Enabled Auto/Disabled Link Down Enabled
1:11 Enabled Auto/Disabled Link Down Enabled
1:12 Enabled Auto/Disabled Link Down Enabled
1:13 Enabled Auto/Disabled Link Down Enabled
1:14 Enabled Auto/Disabled Link Down Enabled
1:15 Enabled Auto/Disabled Link Down Enabled
1:16 Enabled Auto/Disabled Link Down Enabled
1:17 Enabled Auto/Disabled Link Down Enabled
1:18 Enabled Auto/Disabled Link Down Enabled
1:19 Enabled Auto/Disabled Link Down Enabled