D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
144
DGS3100# config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 60
Success.
DGS3100#
show sntp
Purpose To display the SNTP information.
Syntax
show sntp
Description The show sntp command displays SNTP settings information,
including the source IP address, time source and poll interval.
Parameters None.
Restrictions None.
Example usage:
To display SNTP configuration information:
DGS3100#show sntp
Current Time Source : System Clock
SNTP : Disabled
SNTP Primary Server : 10.1.1.1
SNTP Secondary Server : 10.1.1.2
SNTP Poll Interval : 30 sec
DGS3100#
enable sntp
Purpose To enable SNTP server support.
Syntax
enable sntp
Description The enable sntp command enables SNTP server support. SNTP
service must be separately configured (see config sntp). Enabling
and configuring SNTP support override any manually configured
system time settings.
Parameters None.
Restrictions Only administrator and Operator-level users can issue this
command. SNTP settings must be configured for SNTP to function
(config sntp).
Example usage:
To enable the SNTP function:
DGS3100# enable sntp
Success.
DGS3100#

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C