D-Link DGS-3100 SERIES - Igmp Snooping Commands; Config Igmp_Snooping

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
114
17
IGMP SNOOPING COMMANDS
The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command Parameter
config igmp_snooping
[<vlan_name 32> | all] {host_timeout <sec 60-16711450> | router_timeout <sec
1-16711450> | leave_timer <sec 0-16711450> | state [enable | disable]}
config igmp_snooping
querier
[vlan <vlan_name 32> | all] state [enable | disable] {querier_version [IGMPv2 |
IGMPv3]}
config router_port <vlan_name 32> [add | delete] <portlist>
config
router_port_forbidden
<vlan_name 32> [add | delete] <portlist>
enable igmp_snooping
disable igmp_snooping
show igmp_snooping {vlan <vlan_name 32>}
show igmp_snooping
group
{vlan <vlan_name 32>}
show igmp_snooping
forwarding
{vlan <vlan_name 32>}
show router_port {vlan <vlan_name 32> | static | dynamic | forbidden}
Each command is listed in detail, as follows:
config igmp_snooping
Purpose To configure IGMP snooping on the Switch.
Syntax
config igmp_snooping [<vlan_name 32> | all] {host_timeout
<sec 60-16711450> | router_timeout <sec 1-16711450> |
leave_timer <sec 0-16711450> | state [enable | disable]}
Description The config igmp_snooping command configures IGMP snooping
on the Switch.
Parameters <vlan_name 32> − The name of the VLAN for which IGMP snooping
is to be configured.
all – Specifies that IGMP snooping is to be configured for all VLANs
on the Switch.
host_timeout <sec 60-16711450> − Specifies the maximum amount
of time a host can be a member of a multicast group without the
Switch receiving a host membership report. The default is 260
seconds.
router_timeout <sec 1-16711450> − Specifies the maximum amount
of time a route can be a member of a multicast group without the
Switch receiving a host membership report. The default is 300