DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
24
Restrictions None.
Example usage:
To show the jumbo_frames configuration status on the device:
DGS3100# show jumbo_frame
Jumbo frames are disabled.
DGS3100#
locate
Purpose To enable the user to locate the device he is working on.
Syntax
locate
Description The locate command causes the seven segment display of the
currently active switch with Master ID to blink the letter L for 20
seconds.
Parameters None.
Restrictions Only Administrator or operate-level users can issue this command
Example usage:
To display the currently active switch:
DGS3100# locate
Success.
DGS3100#
enable telnet
Purpose To enable the telnet.
Syntax
enable telnet
Description The enable telnet command enables telnet.
Parameters None.
Restrictions Only Administrator or operate-level users can issue this command
Example usage:
To enable telnet:
DGS3100# enable telnet
Success.
DGS3100#
To Next Page
Loading...
