DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
49
Success.
DGS3100#
show snmp traps
Purpose To display SNMP trap support status on the Switch.
Syntax
show snmp traps
Description The show snmp traps command displays the SNMP trap support
status currently configured on the Switch.
Parameters None.
Restrictions None
Example usage:
To view the current SNMP trap support:
DGS3100# show snmp traps
SNMP Traps : enabled
Authenticate Trap : enabled
DGS3100#
config snmp system_contact
Purpose To enter identification information of a contact person who is
responsible for the Switch.
Syntax
config snmp system_contact <sw_contact 0-31>
Description The config snmp system_contact command enters the name
and/or other information to identify a contact person who is
responsible for the Switch. A maximum of 31 characters can be
used.
Parameters <sw_contact 0-31> - A maximum of 31 characters is allowed. A
NULL string is accepted if there is no contact.
Restrictions Only Administrator or operator-level users can issue this command
Example usage:
To configure the Switch contact to ‘MIS Department II’:
DGS3100# config snmp system_contact MIS Department II
Success.
DGS3100#
To Next Page
Loading...
