D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
53
startup − Indicates the Startup Configuration file is to be uploaded.
running − Indicates the Running Configuration file is to be uploaded.
Restrictions None.
Example usage:
DGS3100# upload configuration 1.1.1.23 1\running—config
01–Jan–2000 01:26:11 %COPY–I–FILECPY: Files Copy – source
URL running–config destination URL tftp://1.1.1.23/1\running–
config
… ..01–Jan–2000 01:26:16 %COPY–W–TRAP: The copy operation
was completed success fully
!
158 bytes copied in 00:00:05 [hh:mm:ss]
DGS3100#
config dhcp_auto enable
Purpose To automatically update the switch’s firmware and configuration files
via the web, using options 66 and 67 of the DHCP packets.
Syntax
config dhcp_auto [enable | disable]
Description The config dhcp_auto enable command enables/disables Auto
update feature.
Parameters enable − Enables the Auto-Update feature.
disable − Disables the Auto-Update feature.
Restrictions None.
Example usage:
To automatically update the switch’s firmware and configuration files:
DGS3100# config dhcp_auto enable
The configuration will take place on the next time the device will
get DHCP address.
Success
DGS3100#
show dhcp_auto
Purpose To display the current state of the auto update feature.
Syntax
show dhcp_auto
Description The show dhcp_auto command displays the current state of the
auto update feature.
Parameters None.
Restrictions None.
Example usage:

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C