DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
84
Example usage:
To show multicast filtering settings:
DGS3100# show multicast filtering_mode
Success.
DGS3100#
config dlf filtering_mode
Purpose To configure DLF filtering on the Switch.
Syntax
config dlf filtering_mode [<portlist> | <ch1-32> | all][forward_dlf|
filter_dlf]
Description The config DLF filtering_mode command defines DLF filtering or
forwarding on selected ports/LAGs or all ports and LAGs.
Parameters <portlist> – A port or range of ports to be configured.
<ch1–32> – A LAG or range of LAGs to be configured.
all – All ports and LAGs to be configured.
forward_dlf – Forwards DLF packets.
filter_dlf – Filters DLF packets.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure DLF filtering
DGS-3100# config dlf filtering_mode all filter_dlf
Success.
DGS-3100#
show dlf filtering_mode
Purpose To display DLF filtering settings on the Switch.
Syntax show dlf filtering_mode {portlist>|<ch1-32>|all }
Description The show dlf filtering_mode command displays the DLF filtering
settings.
Parameters <portlist> – A port or range of ports to be configured.
<ch1-32> – A LAG or range of LAGs to be configured.
all – All ports and LAGs to be configured.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To show DLF filtering settings:
DGS-3100# show dlf filtering
To Next Page
Loading...
