D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
13
The system prompts for the account’s new password, which may be
between 0 and 15 characters.
Parameters <username 1-15> − the account username.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the user password of ‘dlink’ account:
DGS3100# config account dlink
Enter a case-sensitive new password:****
Enter the new password again for confirmation:****
Success.
DGS3100#
show account
Purpose To display information about all user accounts on the Switch.
Syntax
show account
Description The show account command displays all account usernames and
their access levels created on the Switch. Up to 31 user accounts
can exist on the Switch at one time.
Parameters None.
Restrictions None.
Example usage:
To display user account information:
DGS3100# show account
Username Access Level
------------------------ --------------------
Dlink User
admin Admin
Total Entries: 2
DGS3100#
show session
Purpose To display information about currently logged-in users.
Syntax
show session
Description The show session command displays a list of all the users that are
logged-in at the time the command is issued. The information
includes the session ID (0 for the first logged-in user, 1 for the next

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C