DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
123
To define the MLD snooping mrouter forbidden:
DGS3100# config mld_snooping mrouter_port_forbidden default add all
Success.
DGS3100#
show mld snooping
Purpose To display mld snooping settings on the Switch.
Syntax
show mld snooping {vlan <vlan_name 32>}
Description The show mld snooping command displays a port from being
defined as a multicast router port by static configuration or by
automatic learning.
Parameters vlan_name 32 – Specifies that the mld snooping applies only to this
previously created VLAN..
Restrictions Only administrator or operator–level users can issue this command
Separate non–consecutive Ethernet ports with a comma and no
spaces; use a hyphen to designate a range of ports. These ports are
defined as connected to a multicast router.
Example usage:
To show the MLD snooping:
DGS3100# show mld_snooping
MLD Snooping Global State : Disabled
Multicast Filtering : Enabled
Vlan Name : default
Host Timeout : 260
Done Timer : 10
Route Timeout : 300
State : Disabled
DGS3100#
show mld_snooping forwarding
Purpose To display mld snooping settings on the Switch.
Syntax
show mld_snooping forwarding {vlan <vlan_name 32>}
Description The show mld_snooping forwarding command displays the
current MLD snooping forwarding table entries currently configured
on the Switch.
Parameters vlan_name 32 – Specifies that the mld snooping applies only to this
previously created VLAN.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To display the MLD snooping forwarding:
To Next Page
Loading...
