D-Link DGS-3100 SERIES - Show Mld_Snooping Groups; Show Mld_Snooping Mrouter_Port

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
124
DGS3100# show mld_snooping forwarding
Total Entries : 0
DGS3100#
show mld_snooping groups
Purpose To display mld snooping group settings on the Switch.
Syntax
show mld_snooping groups {vlan <vlan_name 32>}
Description The show mld_snooping groups command displays the multicast
groups that were learned by MLD snooping.
Parameters vlan <vlan_name 32> – Specifies on which VLAN mld snooping
groups should be shown.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To show the MLD snooping groups:
DGS3100#
TBD
DGS3100#
show mld_snooping mrouter_port
Purpose To display information on dynamically learnt and static multicast
router interfaces.
Syntax
show mld_snooping mrouter_port {vlan <vlan_name 32> | static
| dynamic | forbidden}
Description The show mld_snooping mrouter_port command displays on
dynamically learnt and static multicast router interfaces.
Parameters vlan_name 32 – Displays MLD router ports on specific VLAN.
Static − Displays statically configured MLD router ports.
Dynamic − Displays dynamically configured MLD router ports.
Forbidden – Displays forbidden MLD ports
Restrictions Only administrator or operator-level users can issue this command
Separate non-consecutive Ethernet ports with a comma and no
spaces; use a hyphen to designate a range of ports. These ports are
defined as connected to a multicast router.
Example usage:
To show the MLD_snooping mrouterport:
DGS3100# show mld_snooping mrouter_port
VLAN Name : default
Static router port : (1–48)