DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
70
config stp version
Purpose To globally set the version of STP on the Switch.
Syntax
config stp version [mstp | rstp | stp]
Description The config stp version command sets the version of the spanning
tree to be implemented on the Switch.
Parameters mstp – Sets the Multiple Spanning Tree Protocol (MSTP) globally on
the Switch.
rstp – Sets the Rapid Spanning Tree Protocol (RSTP) globally on
the Switch.
stp – Sets the Spanning Tree Protocol (STP) globally on the Switch.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To set the Switch globally for the Multiple Spanning Tree Protocol (MSTP):
DGS3100# config stp version mstp
Success.
DGS3100#
enable stp
Purpose To globally enable STP on the Switch.
Syntax
enable stp
Description The enable stp command sets the Spanning Tree Protocol to be
globally enabled on the Switch.
Parameters None.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To enable STP, globally, on the Switch:
DGS3100# enable stp
Success.
DGS3100#
disable stp
Purpose To globally disable STP on the Switch.
Syntax
disable stp
Description The disable stp command sets the Spanning Tree Protocol to be
globally disabled on the Switch.
Parameters None.
To Next Page
Loading...
