D-Link DGS-3100 SERIES - Show Link_Aggregation

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
111
Success.
DGS3100#
show link_aggregation
Purpose To display the current link aggregation configuration on the Switch.
Syntax
show link_aggregation {group_id <value 1-32>}
Description The show link_aggregation command displays the current link
aggregation configuration of the Switch.
Parameters group_id <value 1-32> − Specifies the group ID. The Switch allows
up to 32 link aggregation groups to be configured. The group
number identifies each of the groups.
Restrictions None.
Example usage:
To display Link Aggregation configuration:
DGS3100# show link_aggregation
Group ID : 1
Member Port : 5-7,9
Active Port :
Status : Disabled
DGS3100#