DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
45
Success.
DGS3100#
delete snmp host
Purpose To remove a recipient of SNMP traps generated by the Switch’s
SNMP agent.
Syntax
delete snmp host <ipaddr>
Description The delete snmp host command deletes a recipient of SNMP traps
generated by the Switch’s SNMP agent.
Parameters <ipaddr> − The IP address of a remote SNMP manager that
receives SNMP traps generated by the Switch’s SNMP agent.
Restrictions Only Administrator or operator-level users can issue this command
Example usage:
To delete an SNMP host entry:
DGS3100# delete snmp host 10.48.74.100
Success.
DGS3100#
show snmp host
Purpose To display the recipient of SNMP traps generated by the Switch’s
SNMP agent.
Syntax
show snmp host {<ipaddr>}
Description The show snmp host command is used to display the IP addresses
and configuration information of remote SNMP managers that are
designated as recipients of SNMP traps generated by the Switch’s
SNMP agent.
Parameters <ipaddr> − The IP address of a remote SNMP manager that
receives SNMP traps generated by the Switch’s SNMP agent.
Restrictions None.
Example usage:
To display the currently configured SNMP hosts on the Switch:
DGS3100# show snmp host
SNMP Host Table
Host IP Address SNMP Version Community Name / SNMPv3 User Name
--------------- --------------------- ----------------------------------
10.48.76.23 V2c private
10.48.74.100 V3 public
To Next Page
Loading...
Need help?
General
