D-Link DGS-3100 SERIES - Show Gvrp

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
105
Restrictions None.
Example usage:
To display the Switch’s current VLAN settings:
DGS3100# show vlan
VID : 1 VLAN Name : default
VLAN TYPE : static
Member ports : 1-24
Static ports : 1-24
Untagged ports : 1-24g
Forbidden ports :
Total Entries : 1
DGS3100#
show gvrp
Purpose To display the GVRP status for a port list or port channel on the
Switch.
Syntax
show gvrp {<portlist> | <ch1-32>}
Description The show gvrp command displays the GVRP status for a port list or
a port channel on the Switch.
Parameters <portlist> − Specifies a port or range of ports for which the GVRP
status is to be displayed.
<ch1-32> − Specifies a port-channel.
Restrictions None.
Example usage:
To display GVRP port status:
DGS3100# show gvrp 1:1-5
Global GVRP : Disabled
Port PVID GVRP Ingress Checking Acceptable Frame Type
------ ------- ------------- -------------------------- ---------------------------
1:1 1 Disabled Enabled All Frames
1:2 1 Disabled Enabled All Frames
1:3 1 Disabled Enabled All Frames
1:4 1 Disabled Enabled All Frames
1:5 1 Disabled Enabled All Frames
Total Entries : 5