D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
19
Description The disable web command disables the Web-based management
software on the Switch.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To disable HTTP-based management software on the Switch:
DGS3100# disable web
Success.
DGS3100#
save
Purpose To save changes in the Switch’s configuration to non-volatile RAM.
Syntax
save
Description The save command saves the current switch configuration to non-
volatile RAM. The saved switch configuration is loaded to the
Switch’s memory each time the Switch is restarted.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To save the Switch’s current configuration to non-volatile RAM:
DGS3100# save
verwrite file [startup-config] ?[Yes/press any key for
no]....01-Jan-2000 19:03
:59 %COPY-I-FILECPY: Files Copy - source URL
running-config destination URL flas
h://startup-config
01-Jan-2000 19:04:06 %COPY-N-TRAP: The copy
operation was completed successfully
Copy succeeded
Success.
DGS3100#
reboot
Purpose To reboot the Switch. If the Switch is a member of a stack, it may be
rebooted individually, without affecting the other members of the
stack.
Syntax
reboot <box_id 1-6>

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C