D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
139
<state> − This parameter defines whether the port or range of ports
will be enabled or disabled.
Restrictions This command can only be entered if the global command ‘enable
mac_based_access_control’ was previously entered.
Example usage:
To enable MAC Based Access Control on port or port list:
DGS3100# config mac_based_access_control ports 1:1-
5 state enable
DGS3100#
show mac_based_access_control
Purpose To show the port MAC authentication status.
Syntax
show mac_based_access_control {ports [<portlist> | all]}
Description The show mac_based_access_control command displays MAC
authentication status on the configured ports.
Parameters <portlist> − A port or range of ports displayed with the MAC
authentication status.
all − displays all ports with the MAC authentication status.
Restrictions None.
Example usage:
To display MAC Based Access Control on port or port list:
DGS3100# show mac_based_access_control
MAC Based Access Control
----------------------------------------
State :Enabled
Method : Radius
DGS3100# show mac_based_access_control ports 1:5
Port State
----------- -------------
5 Enabled
DGS3100#

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C