DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
140
21
PORT SECURITY COMMANDS
The Port Security commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
config port_security
[<portlist> | all] {admin_state [enable | disable] | max_learning_addr <int 1-64> |
lock_address_mode [Permanent | DeleteOnTimeout | DeleteOnReset] | trap <1-
1000000>}
show port_security {<portlist>}
Each command is listed in detail, as follows:
To Next Page
Loading...
