DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
59
Index Time Log Text
-------- ------------------------------ -----------------------------------
1 03-Jan-2000 17:48:21 %AAA-I-CONNECT: User CLI session for user admin over
telnet , source 10.6.150.34 destination 10.6.41.37 ACCEPTED
2 03-Jan-2000 17:48:02 %AAA-I-DISCONNECT: User CLI session for user admin o
ver telnet , source 10.6.150.34 destination 10.6.41.37 TERMINATED. The Telnet/
SSH session may still be connected.
3 03-Jan-2000 17:38:46 %AAA-I-DISCONNECT: User CLI session for user admin o
ver console , source 0.0.0.0 destination 0.0.0.0 TERMINATED. The Telnet/SSH se
ssion may still be connected.
4 03-Jan-2000 17:26:24 %COPY-W-TRAP: The copy operation was completed succe
ssfully
5 03-Jan-2000 17:26:17 %COPY-I-FILECPY: Files Copy - source URL running-con
fig destination URL flash://startup-config
6 03-Jan-2000 17:25:40 %AAA-I-CONNECT: User CLI session for user admin over
telnet , source 10.6.150.34 destination 10.6.41.37 ACCEPTED
DGS3100#
enable syslog
Purpose To enable the system log to be sent to a remote host.
Syntax
enable syslog
Description The enable syslog command enables the system log to be sent to a
remote host.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable the syslog function on the Switch:
DGS3100# enable syslog
Success.
DGS3100#
disable syslog
Purpose To disable the system log from being sent to a remote host.
Syntax
disable syslog
To Next Page
Loading...
Need help?
General
