DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
65
Parameters <index 1-4> − The syslog host index id. There are four available
indices, numbered 1 to 4.
all − Specifies that the command applies to all hosts.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To delete a previously configured syslog host:
DGS3100# delete syslog host 4
Success.
DGS3100#
show syslog host
Purpose To display the syslog hosts currently configured on the Switch.
Syntax
show syslog host {<index 1-4>}
Description The show syslog host command displays the syslog hosts that are
currently configured on the Switch.
Parameters <index 1-4> − The syslog host index id. There are four available
indices, numbered 1 to 4.
Restrictions None.
Example usage:
To show Syslog host information:
DGS3100# show syslog host
Syslog Global State: Disabled
Host Id Host IP address Severity Facility UDP port
---------- ------------------------ ------------- ------------- ---------------
1 10.1.1.2 All Local0 514
2 10.40.2.3 All Local0 514
3 10.21.13.1 All Local0 514
Total Entries : 3
DGS3100#
clear green-ethernet Cumulative_Energy_Saved
Purpose To clear the Green Ethernet Cumulative_Energy_Saved information.
Syntax
clear green-ethernet Cumulative_Energy_Saved
Description The clear green-ethernet Cumulative_Energy_Saved command
To Next Page
Loading...
Need help?
General
