D-Link DGS-3100 SERIES - Traffic Segmentation Commands; Config Traffic_Segmentation; Show Traffic_Segmentation

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
211
35
TRAFFIC SEGMENTATION COMMANDS
The Traffic Segmentation commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command Parameter
config
traffic_segmentation
[<portlist> | <ch1-32> | all] forward_list [all | <portlist> | <ch1-32>]
show traffic_
segmentation
{<portlist> | ch1-32>|}
Each command is listed in detail, as follows:
config traffic_segmentation
Purpose To configure traffic segmentation on the Switch.
Syntax
config traffic_segmentation [<portlist> | <ch1-32> | all]
forward_list [all | <portlist> | <ch1-32>]
[<portlist> | <ch1-32> | all] forward_list [all | <portlist> | <ch1-
32>]
Description The config traffic_segmentation command configures traffic
segmentation on the Switch.
Parameters <portlist> – A port or a port channel for which the current traffic
segmentation configuration on the Switch is to be displayed.
<ch1-32> − a port-channel.
all − Configures all ports on the Switch.
forward_list – Specifies a port or a port channel to receive forwarded
frames from the source ports specified in the portlist, above.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To configure ports 1 to be able to forward frames to port 11:
DGS3100# config traffic_segmentation 1 forward_list 11
Success.
DGS3100#
show traffic_segmentation
Purpose To display the current traffic segmentation configuration on the
Switch.
Syntax
show traffic_segmentation {<portlist> | ch1-32>|}
Description The show traffic_segmentation command displays the current
traffic segmentation configuration on the Switch.