DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
192
DGS-3100# show lldp ports 2:9
Port ID : 2:9
--------------------------------------------------------------------
Admin Status : Tx_and_Rx
Notification Status : Disabled
Advertised TLVs Option :
Port Description : Enabled
System Name : Enabled
System Drscription : Enabled
System Capabilities : Enabled
MAC/PHY Configuration : Disabled
Management Address : Disabled
DGS-3100#
show lldp local_ports
Purpose To display the Link Layer Discovery Protocol (LLDP) configuration
that is advertised from a specific port.
Syntax
show lldp local_ports <portlist> [mode{brief | normal | detailed}]
Description The show lldp local_ports command displays the configuration
that is advertised from a specific port.
Parameters <portlist> − A port or range of ports to be displayed.
[mode{brief | normal | detailed}] − defines which mode of information
want to be displayed, brief, normal or detailed.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To show the local port information for port 2:9 with mode detailed:
DGS3100# show lldp local_ports 2:9 mode detailed
Port ID : 2:9
-------------------------------------------------------------------
Port ID Subtype : Interface Name
Port ID : 2:9
Port Description : Ethernet Interface
Auto-negotiation support : Supported
Auto-negotiation status : Disabled
Auto-negotiation Advertised Capabilities : other or unknown
Operational MAU type : Unknown
DGS-3100#
show lldp remote_ports
Purpose To display information regarding the neighboring devices discovered
using LLDP.
Syntax
show lldp remote_ports <portlist> [mode{brief | normal |
detailed}]
Description The show lldp remote_ports command displays the information
regarding neighboring devices.
Parameters <portlist> − A port or range of ports to be displayed.
[mode{brief | normal | detailed}] − defines which mode of information
want to be displayed, brief, normal or detailed.
To Next Page
Loading...
Need help?
General
