EasyManuals Logo

D-Link DGS-3100 SERIES Cli Manual

D-Link DGS-3100 SERIES
228 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #199 background imageLoading...
Page #199 background image
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
190
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP Message tx hold multiplier settings:
DGS3100# config lldp message_tx_hold_multiplier 2
Success.
config lldp reinit_delay
Purpose To define the lldp reinint–delay on the switch.
Syntax
config lldp reinit_delay < sec 1 - 10 >
Description The lldp reinit_delay seconds command specifies the minimum
time an LLDP port will wait before reinitializing LLDP transmission.
Parameters sec – Specifies the minimum time in seconds an LLDP port will wait
before reinitializing LLDP transmission. The range is 1 – 10
seconds. The default configuration is 2 seconds.
Restrictions Only Administrator or operator–level users can issue this command.
Example usage:
To configure LLDP reinit delay:
DGS3100# config lldp reinit_delay 1
Success.
DGS3100#
config lldp tx_delay
Purpose To configure the lldp tx_delay on the switch.
Syntax
config lldp tx_delay < sec 1 - 8192 >
Description The lldp tx_delay command specifies the delay between
successive LLDP frame transmissions initiated by value/status
changes in the LLDP local systems MIB, use the lldp tx_delay
command in global configuration mode.
Parameters sec – Specifies the minimum time in seconds an LLDP port will wait
before reinitializing LLDP transmission. The range is 1 – 10
seconds. The default configuration is 2 seconds.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP tx delay:
DGS3100# config lldp tx_delay 1
Success.
DGS3100#

Table of Contents

Other manuals for D-Link DGS-3100 SERIES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link DGS-3100 SERIES and is the answer not in the manual?

D-Link DGS-3100 SERIES Specifications

General IconGeneral
TypeManaged
LayerLayer 2+
Ports10/100/1000BASE-T
SFP Ports2 or 4 (depends on the model)
Additional SFP PortsNo
VLANsYes
StackingYes, Physical Stacking
QoSYes
Jumbo Frame SupportUp to 9K bytes
ManagementWeb-based
Operating Temperature0°C to 40°C
Humidity10% to 90% non-condensing
Standards ComplianceIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
ModelDGS-3100 SERIES
Storage Temperature-40°C to 70°C

Related product manuals