D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
107
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To display the Switch’s current VLAN_trunk settings:
DGS-3100# show vlan_trunk
Vlan Trunking : Enabled
Configured Ports : 1:(1-2)
DGS-3100#
config vlan_trunk ports
Purpose To configure VLAN Trunking port settings on the Switch.
Syntax
config vlan_trunk ports <portlist> state [enable | disable]
Description The config vlan_trunk ports command configures the VLAN
trunking port settings on the Switch. The user can enable VLAN
Trunking and define ports to be added to the VLAN Trunking
settings.
Parameters <portlist> − A port or range of ports for which to configure VLAN
Trunking.
state [enable | disable] − enable and disable VLAN trunking.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To define VLAN Trunking:
DGS3100# config vlan_trunk ports 1-2 state disable
Success.
DGS3100#
enable asymmetric_vlan
Purpose To enable Asymmetric VLAN on the switch.
Syntax
enable asymmetric_vlan
Description The enable asymmetric_vlan command, along with the disable
enable asymmetric_vlan command below, is used to enable and
disable Asymmetric VLAN on the Switch
Parameters None.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To enable Asymettric VLAN on the switch:
DGS-3100# enable asymmetric_vlan

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C