DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
149
23
ROUTING TABLE COMMANDS
The Routing Table commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
create iproute [default] <ipaddr> {<metric 1-65535>}
delete iproute [default]
show iproute
Each command is listed in detail, as follows:
create iproute
Purpose To create IP route entries in the Switch’s IP routing table.
Syntax
create iproute [default] <ipaddr> {<metric 1-65535>}
Description The create iproute command creates a static IP route entry in the
Switch’s IP routing table.
Parameters default – The entry is the default IP route entry in the Switch’s
routing table.
<ipaddr> – The gateway IP address for the next hop router.
<metric 1-65535> – The routing protocol metric entry representing
the number of routers between the Switch and the IP address
above. The default setting is 1.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To add the default static address 10.48.74.121, with a metric setting of 1, to the routing table as the default route:
DGS3100# create iproute default 10.48.74.121 1
Success.
DGS3100#
delete iproute
Purpose To delete a default IP route entry from the Switch’s IP routing table.
Syntax
delete iproute [default]
Description The delete iproute command deletes an existing default entry from
the Switch’s IP routing table.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
To Next Page
Loading...
Need help?
General
