D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
191
show lldp
Purpose To display the Link Layer Discovery Protocol (LLDP) on the switch.
Syntax
show lldp configuration port <portlist>
Description The show lldp configuration displays the LLDP configuration on
the switch.
Parameters <portlist> - Specifies a port or range of ports for which the lldp status
is to be displayed..
Restrictions None.
Example usage:
To show LLDP settings:
DGS3100# show lldp
Information
MAC Address
0:22:aa:bb:33
: DGS-3100
kable PoE L2
naged Switch
: Bridge
onfigurations
: Enabled
: Disabled
terval : 5
Multiplier : 2
: 1
y : 1
nterval : 5
DGS3100#
LLDP System
Chassis ID Subtype :
Chassis ID : 00:0
System Name
System Description : DGS-3100-48P Gigabit stac
Ma
System Capabilities
LLDP C
LLDP Status
LLDP Forward Status
Message Tx In
Message Tx Hold
Tx Delay
Reinit Dela
Notification I
show lldp ports
Purpose To display the Link Layer Discovery Protocol (LLDP) ports
configuration on the switch.
Syntax
show lldp ports <portlist>
Description The show lldp ports command displays the information regarding
the ports.
Parameters <portlist> − A port or range of ports to be displayed.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To show the information for port 2:9:

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C