D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
188
Restrictions Only Administrator or operator–level users can issue this command.
Example usage:
To enable LLDP on the switch:
DGS3100# enable lldp
Success.
DGS3100#
disable lldp (global)
Purpose To disable LLDP on the switch.
Syntax
disable lldp
Description The disable lldp command disables the Link Discovery Protocol
(LLDP) on the switch.
Parameters None
Restrictions Only Administrator or operator–level users can issue this command.
Example usage:
To disable LLDP on the switch:
DGS3100# disable lldp
Success.
DGS3100#
enable lldp forward_message
Purpose To enable forwarding of LLDP message on the switch. When LLDP
is disabled
Syntax
enable lldp forward_message
Description The enable lldp forward message command enables lldp forward
messaging on the switch.
Parameters None
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable LLDP forward message on the switch:
DGS3100# enable lldp forward_message
Success.
DGS3100#

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C