D-Link DGS-3100 SERIES - Banner Commands; Config Login_Banner

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
156
25
BANNER COMMANDS
The Banner commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
config login_banner <text 0-159>
show login_banner
Each command is listed in detail, as follows:
config login_banner
Purpose Used to define telnet login banner
Syntax
config login_banner <text 0-159>
Description This command allows definition of the login banner text.
Parameters <text 0 – 159> - up to 160 characters
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To define telnet login banner to show ‘D-Link’:
DGS3100# config login_banner D-Link
Success.
DGS3100#
show login_banner
Purpose Used to show the login banner.
Syntax
show login_banner
Description This command allows display of the telnet login banner
Parameters None
Restrictions None
Usage Example:
To show the login banner:
DGS3100# show login_banner
Login banner is : D-Link
DGS3100#