D-Link DGS-3100 SERIES - Config Multicast Filtering_Mode; Show Multicast Filtering_Mode

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
83
1 default 00-01-30-10-2C-C7 10 Dynamic
1 default 00-01-30-FA-5F-00 10 Dynamic
1 default 00-02-3F-63-DD-68 10 Dynamic
More: <space>, Quit: q, One line: <return>l
To display the aging time:
DGS3100# show fdb aging_time
Unicast MAC Address Aging Time = 5
DGS3100#
config multicast filtering_mode
Purpose To configure multicast filtering.
Syntax
config multicast filtering_mode [<portlist> | <ch1-32> |
all][forward_unregistered_groups | filter_unregistered_groups]
Description The config multicast filtering_mode command enables filtering of
multicast addresses.
Parameters <portlist> - A port or range of ports to be configured.
<ch1–32> - A LAG ar range of LAGs to be configured.
all - All ports to be configured.
forward_unregistered_groups - Forwards unregistered multicast
packets.
filter_unregistered_groups - Filter unregistered multicast packets.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure multicast filtering
DGS3100# config multicast filtering_mode 1
filter_unregistered_groups
Success.
DGS3100#
show multicast filtering_mode
Purpose To display multicast filtering settings on the Switch.
Syntax show multicast filtering_mode {portlist>|<ch1-32>|all }
Description The show multicast filtering_mode command displays the
multicast filtering settings..
Parameters <portlist> - A port or range of ports to be configured.
<ch1-32> - A LAG ar range of LAGs to be configured.
all – All ports to be configured.
Restrictions Only Administrator or operator-level users can issue this command.