DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
185
30
LACP COMMANDS
The LACP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
config lacp port_priority <portlist> [priority 1-65535] [timeout <90sec | 3sec>]
show lacp {<portlist>}
Each command is listed in detail, as follows:
config lacp port_priority
Purpose To set the priority value of a physical port in an LACP group.
Syntax
config lacp port_priority <portlist> [priority 1-65535] [timeout
<90sec | 3sec>]
Description The config lacp port_priority command sets the LACP priority
value and administrative timeout of a physical port or range of ports
in an LACP group.
Parameters <portlist> - A port or range of ports to be configured.
<priority 1-65535> - Specifies the LACP priority value for a port or
range of ports to be configured. The default is 1.
<timeout> - Specifies the administrative LACP timeout.
• 90sec – Specifies the LACP timeout to be 90 seconds. This
is the default.
• 3sec – Specifies the LACP timeout to be 3 seconds.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure the LACP priority of a port:
DGS3100# config lacp port_priority 1 priority 2
Success.
DGS3100#
show lacp
Purpose To display current LACP port mode settings.
Syntax
show lacp {<portlist>}
Description The show lacp command displays the current LACP mode settings.
Parameters <portlist> - A port or range of ports whose LACP settings are to be
displayed.
If no parameter is specified, the system displays the current LACP
To Next Page
Loading...
