D-Link DGS-3100 SERIES - Show Arpentry; Config Arp_Aging Time

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
153
show arpentry
Purpose To display the ARP table.
Syntax
show arpentry {ipif system | ipaddress <ipaddr> | static }
Description The show arpentry command displays the current contents of the
Switch’s ARP table.
Parameters ipif system <ipif_name 12> – The name of the IP interface, the end
node or station for which the ARP table entry was made, resides on.
ipaddress <ipaddr> – The network address corresponding to the IP
interface name above.
static – Displays the static entries to the ARP table.
Restrictions None.
Example usage:
To display the ARP table:
DGS3100# show arpentry
ARP timeout : 150 Seconds
Interface IP Address MAC Address Type
------------- ---------------- ------------------------- ---------------
System 10.6.41.33 00:00:b0:07:07:49 dynamic
System 10.6.41.49 00:20:18:2a:56:18 dynamic
Total Entries = 2
DGS3100#
config arp_aging time
Purpose To configure the age-out timer for ARP table entries on the Switch.
Syntax
config arp_aging time <value 1-65535 >
Description The config arp_aging time command sets the maximum amount of
time, in minutes, that an ARP entry can remain in the Switch’s ARP
table, without being accessed, before it is dropped from the table.
Parameters time <value 1-65535> – The ARP age-out time, in minutes. The
value may be in the range of 1-65535 minutes, with a default setting
of 20 minutes.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure ARP aging time:
DGS3100# config arp_aging time 30
Success.
DGS3100#