DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
196
32
STACKING COMMANDS
The Stacking commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
config box_id current_box_id <value 1-6> new_box_id [auto | 1 | 2 | 3 | 4 | 5 | 6]
show stack_information
config box_id
Purpose To change the unit ID (stack membership number).
Syntax
config box_id current_box_id <value 1-6> new_box_id [auto | 1 |
2 | 3 | 4 | 5 | 6]
Description The config box_id command changes the unit ID (stack
membership number). The command takes effect only after
rebooting the device.
Parameters current_box_id <value 1-6> - Specifies the unit’s current stack
membership number.
new_box_id <auto | 1 | 2 | 3 | 4 | 5 | 6> - Specifies the units’s new
stack membership number. If auto is specified, the system
automatically defines the unit’s new ID.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To change the unit ID from 1 to 2:
DGS3100# config box_id 1 new_box_id 2
DGS3100#
show stack_information
Purpose To display information about the units in the stack.
Syntax
show stack_information
Description The show stack_information command displays information about
the units in the stack, including the unit numbers, firmware version,
hardware version, Master ID and Backup ID.
Parameters None.
Restrictions None.
Example usage:
To Next Page
Loading...
