DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
195
Purpose To define LLDP management basic TLVs advertisement on a port or ports.
Syntax
config lldp ports ports [<portlist>|all] dot3_tlvs
mac_phy_configuration_status [enable | disable]
Description The config lldp dot3 TLVs command defines if lldp will advertise the
mac_phy_configuration_status the command is per port on the switch.
Parameters ports – ports.
dot3_tlvs mac_phy_configuration_status – defines if the advertisement is
enabled or disabled
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP mac_phy_configuration status:
DGS3100# config lldp ports 1 dot3_tlvs mac_phy_configuration_status
enable
Success.
DGS3100#
To Next Page
Loading...
