DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
27
show dhcp_relay ipif
Purpose To display the DHCP Relay settings on the Switch.
Syntax
show dhcp_relay ipif
Description The show dhcp_relay ipif command displays the DHCP Relay
status and list of servers defined as DHCP Relay servers on the
Switch.
Parameters None.
Restrictions None.
Example usage:
To display DHCP Relay settings:
DGS-3100#show dhcp_relay ipif
DHCP Relay Status : Enabled
Server IP
----------------------------
10.6.150.49
DGS-3100#
show tech_support
Purpose To display system and configuration information. to provide to the
Technical Assistance Center when reporting a problem, use the
show tech-support command.
Syntax
show tech_support [config | memory]
Description The show tech_support command displays system and
configuration information. to provide to the Technical Assistance
Center when reporting a problem.
By default, this command displays the output for technical-support-
related show commands. Use keywords to specify the type of
information to be displayed. If you do not specify any parameters,
the system displays all configuration and memory data.
The show tech_support command may time out if the configuration
file output takes longer to display than the configured session
timeout time. If this happens, enter a set logout timeout value of 0 to
disable automatic disconnection of idle sessions or enter a longer
timeout value.
The show tech_support command output is continuous; it does not
display one screen at a time. To interrupt the output, press Esc.
Parameters [memory] — Displays memory and processor state data.
[config] — Displays the switch configuration within the CLI
commands supported on the device.
Restrictions Only Administrator-level users can issue this command..
Example usage:
To display the config options:
DGS-3100#show tech_support [config]
To Next Page
Loading...
Need help?
General
