DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
40
to delete. This string is used like a password to give remote SNMP
managers access to MIB objects in the Switch’s SNMP agent.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To delete the SNMP community string ‘dlink’:
DGS3100# delete snmp community dlink
Success.
DGS3100#
show snmp community
Purpose To display SNMP community strings configured on the Switch.
Syntax
show snmp community {<community_string 20>}
Description The show snmp community command displays SNMP community
strings that are configured on the Switch.
Parameters <community_string 20> − A string of up to 20 alphanumeric
characters that is used to identify members of an SNMP community.
This string is used like a password to give remote SNMP managers
access to MIB objects in the Switch’s SNMP agent.
Restrictions None.
Example usage:
To display the currently entered SNMP community strings:
DGS3100# show snmp community
SNMP Community Table
Community Name View Name Access Right
-------------------------------- -------------------------- ------------------------
dlink ReadView read write
private CommunityView read write
public CommunityView read only
Total Entries: 3
DGS3100#
config snmp engineID
Purpose To configure a name for the SNMP engine on the Switch.
Syntax
config snmp engineID [default | <snmp_engineID 10-64>]
Description The config snmp engineID command configures a name for the
SNMP engine on the Switch.
To Next Page
Loading...
Need help?
General
