D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
161
disable ssh
Purpose To disable SSH.
Syntax
disable ssh
Description The disable ssh command disables SSH on the Switch.
Parameters None.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To disable SSH:
DGS3100# disable ssh
Success.
DGS3100#
config ssh authmode
Purpose To configure the SSH authentication mode setting.
Syntax
config ssh authmode publickey [enable | disable]
Description The config ssh authmode command configures the SSH
authentication mode for users attempting to access the Switch.
Parameters publickey [enable | disable] – Specifies that a publickey configuration
set on a SSH server is to be used for authentication.
Enables or disables SSH authentication on the Switch.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To enable the SSH authentication mode:
DGS3100# config ssh authmode publickey enable
Success.
DGS3100#
show ssh authmode
Purpose To display the SSH authentication mode setting.
Syntax
show ssh authmode
Description The show ssh authmode command displays the current SSH
authentication set on the Switch.
Parameters None.
Restrictions None.

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C