D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
57
show utilization
Purpose To display real-time port utilization statistics.
Syntax
show utilization [ports | cpu]
Description The show utilization command displays the real-time utilization
statistics for ports in bits per second (bps) for the Switch, and for the
CPU in percentage..
Parameters None
Restrictions None.
To display the port utilization statistics:
DGS-3100# show utilization ports
Port TX/sec RX/sec Util
----- ---------- ---------- ------
1:1 2424 1968 0%
1:2 0 0 0%
1:3 0 0 0%
1:4 0 0 0%
1:5 0 0 0%
1:6 0 0 0%
1:7 0 0 0%
1:8 0 0 0%
1:9 0 0 0%
1:10 0 0 0%
1:11 0 0 0%
1:12 0 0 0%
1:13 0 0 0%
1:14 0 0 0%
1:15 0 0 0%
1:16 0 0 0%
1:17 0 0 0%
1:18 0 0 0%
1:19 0 0 0%
DGS-3100#
To display the cpu utilization statistics:
DGS-3100# show utilization cpu
CPU utilization
-----------------------------------------------------------------------------
Five seconds - 10% One minute - 8% Five minutes - 10%
DGS-3100#

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C