DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
126
19
802.1X COMMANDS
The 802.1X commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
enable 802.1x
disable 802.1x
config 802.1x <feap> [enable | disable]
show 802.1x
auth_state
{ports <portlist>}
show 802.1x
auth_configuration
{ports <portlist>}
config 802.1x
auth_parameter ports
[<portlist> | all] [default | { port_control [force_unauth | auto | force_auth] |
quiet_period <sec 0-65535> | tx_period <sec 1-65535> | supp_timeout <sec 1-
65535> | server_timeout <sec 1-65535> | max_req <value 1-10> | reauth_period
<sec 300-4294967295> | enable_reauth [enable | disable]}]
config 802.1x init port_based ports [<portlist> | all]
config 802.1x
auth_protocol
[radius | none]
config 802.1x reauth port_based ports [<portlist> | all]
config radius add
<server_ip> ][ key <passwd 128>] [default | {auth_port <udp_port_number 1-
65535> | acct_port <udp_port_number 1-65535>}]
config radius delete <server_ip>
config radius
<server_ip> {| key <passwd 128> | auth_port <udp_port_number 1-65535> |
acct_port <udp_port_number 1-65535>}
show radius
config 802.1x
auth_mode
ports <portlist> [port_based | mac_based]
create 802.1x
guest_vlan
<vlan_name 32> state [enable| disable]
delete 802.1x
guest_vlan
config 802.1x
guest_vlan ports
<portlist> state [enable| disable]
show 802.1x
guest_vlan
Each command is listed in detail, as follows: