D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
In the above example, the Switch was assigned an IP address of 1.1.1.10 with a subnet mask of 255.0.0.0.
The system message Success indicates that the command was executed successfully. The Switch can
now be configured and managed via Telnet, SNMP MIB browser and the CLI or via the Web-based
management agent using the above IP address to connect to the Switch.
NOTE: The DGS-3100 series of switches have the capability to be configured to have no IP
address. This function maybe used to disable Layer 3 functions of the Switch. When the IP
address is disabled, the Switch can only be managed through the console port. Other
management applications such as Telnet, Web-based and SNMP cannot be used to manage the
Switch when the switch has no IP address.
3

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C