D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
77
internalCost – The relative cost of forwarding packets to specified
ports when an interface is selected within an STP instance. The
default setting is auto. There are two options:
• auto – Specifies setting the quickest route automatically and
optimally for an interface. The default value is derived from
the media speed of the interface.
• value 1-200000000 – Specifies setting the quickest route
when a loop occurs. The value may be in the range of 1-
200000000. A lower internalCost represents a quicker
transmission.
priority <value 0-240> - The priority for the port interface The value
may be between 0 and 240. A lower number denotes a higher
priority. A higher priority designates the interface to forward packets
first.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To designate ports 1 through 5 on module one, with instance ID 2, to have an auto internalCost and a priority of 16:
DGS3100# config stp mst_ports 1:1-5 instance_id 2 internalCost auto
priority 16
Success.
DGS3100#

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C