Danfoss Turbocor VTT Series - Figure 160 - Stator Cooling Temperature Sensor; Figure 161 - Radial Bearing Mylar Insertion

125 of 165
M-SV-VT-001-EN Rev. A
Compressor Components
Stator Cooling
Temperature Sensor
13. Remove the M4x20 screw, washer, and lock washer that secure the Stator Cooling Temperature
Sensor.
Figure 160 - Stator Cooling
Temperature Sensor
14. Insert two (2) pieces of Mylar between the Compressor shaft and the Rear Radial Bearing
Assembly.
Figure 161 - Radial Bearing
Mylar Insertion
Mylar Insertion
Points
Stator Cooling
Temperature
Sensor Screw - 4
Nm (35 in.lb.)