Danfoss Turbocor VTT Series - Power Side; Motor Power Cover; Figure 46 - Motor Power Cover (Revision A); Figure 47 - Motor Power Cover (Revisions B and Later)

52 of 165 M-SV-VT-001-EN Rev. A
Torque to 6 Nm
(53 in.lb.)
(4 places)
Compressor Components
3.3 Power Side
3.3.1 Motor Power Cover
The Motor Power Cover provides protection for the connection of the cables from the VFD to the
Compressor motor. There are two (2) variants of this cover as shown below. The most noticeable
dierence is there are four (4) mounting screws for the “A” Revision while the later revisions have six
(6) mounting screws.
Figure 46 - Motor Power
Cover (Revision A)
Figure 47 - Motor Power
Cover (Revisions B and Later)
Torque to 6 Nm
(53 in.lb.)
(6 places)