Danfoss Turbocor VTT Series - Figure 83 - J16 (Revisions C and Later); Figure 84 - J4 (Revisions C and Later)

80 of 165 M-SV-VT-001-EN Rev. A
Compressor Components
Removal (Revisions C and Later):
1. Isolate the Compressor and VFD power as described in the “Electrical Isolation of the
Compressor/VFD” section of this manual.
2. Remove the Service Side Cover.
3. Disconnect the J16 connector from the CCM Board.
Figure 83 - J16
(Revisions C and Later)
Figure 84 - J4
(Revisions C and
Later)
J16 Connector
4. Remove J4 from the DC-DC Board.
5. Remove the cable between the CCM and the DC-DC.
J4 Connector