127 of 165
M-SV-VT-001-EN Rev. A
Compressor Components
• • • CAUTION • • •
Do not allow the Radial Bearing Assembly to contact/rub the Compressor shaft during removal.
Damage to the shaft and or bearing assembly may occur.
17. Slowly tighten the four (4) jacking screws evenly, in a crisscross pattern. Continue this until the
Radial Bearing Assembly can be removed by hand.
18. While supporting the shaft, carefully slide out the Radial Bearing Assembly.
Figure 164 - Radial Bearing
Assembly Removal
19. Slide a small piece of Mylar underneath the shaft and gently lower the shaft onto the Stator.
20. Disconnect the internal Stator harness connector and test as described in the “Stator Thermistor
Resistance Verification” section of this manual.
Figure 165 - Stator View
Stator Temperature
Sensor Connector
To Next Page
Loading...
